Installing Silvus Antennas

We have refined the antenna placement and direction on PRISM Sky to improve and enhance the overall signal strength between PRISM Sky and the ground station/KONTACT. It is crucial to follow this document as closely as possible, specifically the antenna direction, to achieve the best results possible.

1. Loosen the M3 bolts circled in red below. Figure 1 (click to enlarge photo)

Fig. 1

1. Slide either the front or the rear antenna rail through the two guides, as centered as possible from front to back.

2. Tighten down the M3 bolts circled in red and tighten to 11in-lbs. Figure 2.

WARNING: Take note of the orientation of the antenna extension itself! This is very important.

Fig. 2

1. Thread the antenna extension cable into the SMA connector on the side of the drone. Tighten it with your fingers as tight as you can; it is not necessary to use tools to tighten it further. Figure 3.

Fig. 3

1. Use the included Velcro strips to secure the antenna extension cable to the antenna rail. This is purely to take up the extra slack and eliminate the possibility for the cable to get caught in one of the propellers. Figure 4.

Fig. 4

1. Repeat the above steps for the opposite antenna rail.

2. Ensure all M3 bolts are fully tightened before flying and that both antenna extensions are connected to the aircraft as well as the cables secured to the antenna rails.

CAUTION: Be sure to install antennas BEFORE powering on the aircraft to prevent damaging the radio!